Fig. 31: Mounting kit for building heat pump circuit
1
Air heater in the device
2
Screw connection included in the scope of
delivery, installed on site
3
Control valve, (mounting kit for building heat
pump circuit)
4
Throttle valve, (mounting kit for building heat
pump circuit)
5
Motor valve, (mounting kit for building heat pump
circuit)
6
Temperature sensor, water evaporator feed and
return, included in the scope of delivery, installed
on site,
7
Temperature sensor, evaporator outlet (freeze
protection), included in the scope of delivery,
installed on site
8
Screw connection included in the scope of
delivery, installed on site
9
Water evaporator in the device
10 Pipeline insulation, installation on site
11 Drain valve, (mounting kit for building heat pump
circuit)
12 Connection of client’s piping network, heating
system feed and return, installed on site
13 Mounting plate for mounting kit
Pre-assembled unit
Individual parts of the pre-assembled unit
1.
Install the pre-assembled, three-piece building heat pump cir-
cuit (Fig. 31) on the device on the supplied mounting plate
(Fig. 30/13) and install it on the water evaporator (Fig. 30/9)
via a detachable connection to the connections (Fig. 31/8) of
the building heat pump circuit.
2.
Install the air heater (Fig. 30/1) via a detachable connection
to the connections (Fig. 31/2) of the building heat pump cir-
cuit.
3.
Connect the connections (Fig. 31/12) to the client’s pipe net-
work via a detachable connection. Pay attention to the feed
and return for the heating system.
4.
The client must install a dirt trap in the supply line.
5.
Assemble a bleeder valve at the highest point of the building
heat pump circuit.
Connecting the building heat pump
25.08.2022
Device type: Menerga TX - ThermoCond
39
