fiGura 3. CompaTible baCk boxeS:
BACK BOX A- 105mm X 105mm
BACK BOX B- 65mm ROUND
BACK BOX E- 4X4
BACK BOX C- 86mm X 86mm
BACK BOX G- 60mmX 60mm
BACK BOX D- 4X4
BACK BOX H- 2X4
BACK BOX F- DOUBLE-GANG
BACK BOX I- SINGLE-GANG
BACK BOX J- 4 inch OCTAGON
2.36 in.[60 mm]
2.36 in. [60 mm]
3.28 in. [83.3 mm]
3.28 in. [83.3 mm]
1.81 in. [46 mm]
1.77 in.[45 mm]
2.6 in. [66 mm]
3.54 in. [90 mm]
3.38 in. [85.7 mm]
3.38 in. [85.7 mm]
2.0 in. [50.8 mm]
3.7 in.[94 mm]
3.7 in.[94 mm]
2.47 in. [62.9 mm]
3.50 in. [88.9 mm]
3.28 in. [83.3 mm]
A0434-00
A0435-00
–
+
–
FACP
INPUT
NEXT
DEVICE
(or EOL Resistor)
(or Previous Device)
+
fiGura 2. wirinG:
mounTinG wall or CeilinG proDuCT
1. Attach the mounting plate as shown in Figure 1
(mounting screws are NOT supplied). The mount-
ing plate is compatible with the boxes shown in
Figure 3.
2.
Connect field wiring to terminals, located on
back of product, as shown in Figure 2.
SS-120-003
2 I56-3690-000R
3. To attach product to mounting plate, hook the
tabs on the product housing into the grooves on
the mounting plate shown in Figure 4A.
4.
Next, swing product into position while
making sure that the tabs on the back of
the product housing fully engage with the
mounting plate and then secure by tighten-
ing the supplied mounting screw as shown in
Figure 4A and 4B. (see Figures 4A, 4B and 4C
on page 2)
5. If the round trim ring is required, it must be
installed before tightening the front mounting
screw. To install, align the round trim ring with
the product housing and push into place. Once
installed, secure the product with the mounting
screw as shown in Figure 5 on page 2.
