background image

D650-03-00

4

I56-491-06R

©

2002 System Sensor

Three-Year Limited Warranty

System Sensor warrants its enclosed smoke detector base to be free from
defects in materials and workmanship under normal use and service for a
period of three years from date of manufacture. System Sensor makes no
other express warranty for this smoke detector base. No agent, representa-
tive, dealer, or employee of the Company has the authority to increase or
alter the obligations or limitations of this Warranty. The Company’s obli-
gation of this Warranty shall be limited to the repair or replacement of any
part of the smoke detector base which is found to be defective in materi-
als or workmanship under normal use and service during the three year
period commencing with the date of manufacture. After phoning System
Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return
Authorization number, send defective units postage prepaid to: System

Sensor, Returns Department, RA #__________, 3825 Ohio Avenue, St.
Charles, IL 60174. Please include a note describing the malfunction and
suspected cause of failure. The Company shall not be obligated to repair or
replace units which are found to be defective because of damage, unrea-
sonable use, modifications, or alterations occurring after the date of man-
ufacture. In no case shall the Company be liable for any consequential or
incidental damages for breach of this or any other Warranty, expressed or
implied whatsoever, even if the loss or damage is caused by the Company’s
negligence or fault. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you. This Warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.

Please refer to insert for the Limitations of Fire Alarm Systems

Содержание B501BH

Страница 1: ...0 to 93 Relative Humidity Electrical Ratings External Supply Voltage 17 to 32 VDC Standby Current 1 0 mA maximum Alarm Current 15 mA maximum Maximum Ripple Voltage 10 of supply voltage Start up Capacitance 200 µF Communication Initiating Loop Supply Current Draw from Remote Output of Sensor to turn on Horn 700 µA maximum Sound Output Greater than 90 dBA measured in anechoic room at 10 feet 24 volt...

Страница 2: ...should be color coded to reduce the likelihood of wiring errors Improper connections can prevent a system from respond ing properly in the event of a fire For signal wiring the wiring between interconnected sen sors or modules it is recommended that the wire be no smaller than 18 gauge 1 0 square mm Wire sizes up to 12 gauge 2 5 square mm may be used with the base For best system performance the p...

Страница 3: ... system is undergoing mainte nance and therefore will be temporarily out of service Disable the system undergoing mainte nance to prevent unwanted alarms Sensors and bases must be tested after installation and as an integral part of periodic maintenance Test the B501BH as follows 1 Reverse the polarity of the external 24VDC supply All B501BH bases on the loop should sound in approximate ly 10 seco...

Страница 4: ...r 800 SENSOR2 736 7672 for a Return Authorization number send defective units postage prepaid to System Sensor Returns Department RA __________ 3825 Ohio Avenue St Charles IL 60174 Please include a note describing the malfunction and suspected cause of failure The Company shall not be obligated to repair or replace units which are found to be defective because of damage unrea sonable use modificat...

Отзывы: