SYSFORM D-50A, Руководство по эксплуатации, Страница: 5 / 9

3. Installation
1. Unpack the machine from the carton by holding the two square steel bars at the bottom
of the machine.

Caution: Don
’t pull the shell of the machine.
2. Assemble the table to the machine and fix it using two screws on both sides.
3. Plug the machine into to the mains. Switch the machine on. Make sure the machine is
good grounded connection.
4. Operation
1. Check for any staples or clips in the sheets before drilling to avoid any damage to the
machine.
2. Set the rear and front position of the table and tighten its two fixing screws on both sides
of the machine.
3. Select a drilling bit with desired diameter. Open the transparent plastic cover. Push the
drill bit upward into the base to the top position then tighten the two grub screws. Close
the transparent plastic cover.
4. Load the sheets onto the table. Press the clamping bar downward at the center of the bar
to clamp the sheets tightly (shown in Fig 2).
5. Select the desired drilling distance by turning the hexagonal bar and moving the table in
place.
6. Drill the sheets by pressing down the
“start” key on the console panel. The bit will drill
downward and return to the original position after finishing its work. Move the front table
for subsequent drilling.
7. Take the drilled sheets away by releasing the clamping bar (shown in Fig 3).
5. Console panel (shown in Fig 4)
1. Buttons
RESET: Have the drilling bit return to the original position.
UP: Have the drilling bit go upward.
DOWN: Have the drilling bit go downward..
START: Have the machine drill automatically.
Drilling: Have the drilling bit rotate.
2. Lamps
COVER: transparent plastic cover is open.
BIT: The machine is buzzing due to
an overload. Press the “RESET” key to reset the
machine and check for any paper jam in the drilling bit or a blunt drilling bit.
3. Power Switch
Switch on/off the machine.
3