Quick Installation Guide
2. Installation
2.1 Connection
• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
• Connecting Alarms
AI(Alarm In) :
You can use external devices to signal the network camera to react on events. Mechanical or
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G(Ground) :
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.
Alarm Out :
The network camera can activate external devices such as buzzers or lights. Connect the device
to the AO (Alarm Out) and G (Ground) connectors.
Micro SD memory slot on the Rear Board
Remove the rear cap of the camera to insert the SD memory card.
•
Connecting the Power
Connect the power of DC12V or AC24V for the network camera. Connect the po) pole to
the ‘+’ position and the negative(-) pole to the ‘-‘ position for the DC power.
• Connecting Service Monitor Port
Service monitor port is used for an easy OSD setup. To make changes in the OSD menu, please
use the OSD controller provided optionally with your camera purchase. You can set Camera Title
and IP Address.
5
