SYNTHR SYNTHR3, Руководство пользователя

Страница: 10 / 38

Page 10
SYNTHR3 Manuel V1.01 EN
MODULATIONS
LFO1 (LFO Mode of VCO3)

LFO On: with frequency display in the knob. In this case the VCO3 no longer exists in the Mixer.

Range selector: 5 frequency ranges

-2 from 0,37 to 0,7 Hz

-1 from 0,74 to 1,4 Hz

0 from 1,5 to 2,8 Hz

+1 from 3 to 5,5 Hz

+2 from 6 to 11 Hz

Frequency potentiometer corresponding to fine tuning

djustable frequency modulation input: Aftertouch or
Modulation Envelope or LFO2
Simultaneous outputs: Triangle, Sawtooth, Reverse Sawtooth, Square
Note:

Remember to re-tune the frequency to return to VCO mode..
LFO1 has several possible destinations. If the LFO1 button is not pressed it is in VCO mode and therefore in the audio range.
This can be used to do frequency modulation on the other VCOs as well as on the filters
LFO2 (Electricdruid ™)

Range selector: 4 frequency ranges

1 from 0,05 to 12,5 Hz

2 from 0,1 to 25 Hz

3 from 0,2 to 50 Hz

4 from 0,4 to 100 Hz

Frequency potentiometer

Waveform distortion potentiometer:

Examples :
* The position respecting the waveform is at noon or 50%
otherwise the waveform is distorted. In the case of the square
waveform, this potentiometer acts on the duty cycle (PW).

Sample & Hold sample rate potentiometer acting on any
waveform.

Waveform selector among 8 and 8 more by pressing "Alt".

LFO On button: without it no exit . The LED shows the frequency.

Knobs for triggering the LFO by the modulation envelope.
LFO trigger button by Aftertouch