SYNTHESIS TECHNOLOGY
PAGE
6
MOTM-110 ASSEMBLY
WWW.SYNTHTECH.COM
Locate the 470K resistors and solder into R6 & R25.
Locate the 200K resistors and solder into R10 & R22.
Locate the 2M2 (2.2Meg) resistor and solder into R17.
Locate the 6K8 (6.8K) resistor and solder into R18.
Locate the 300K resistors and solder into R15 & R19.
Locate the 680 ohm resistor and solder into R20.
Locate the 39K resistor and solder into R5.
Locate the 27K resistor and solder into R26.
PART #2: BOARD WASH #1
Verify all the resistors are in the correct position.
Verify all the resistors are flat on the board. Correct if needed.
Wash the board in warm water, gently scrubbing both sides.
Shake the board a couple of time, blot dry with an old towel (the leads will frazzle
the good towel). Let dry about 15 minutes.
PART #3: CAPACITORS
Locate the
CAPACITOR
bag.
Locate the 150pf axial
ceramic caps. They are marked 151. Solder into C2 & C3.
Locate the 22pf axial ceramic caps. They are marked 220. Solder into C14 & C19.
Locate the 0.1mfd axial ceramic caps. Some kits have these pre-cut and bent to the
correct spacing. Solder into C12, C13, C15 - C17.
Locate the 0.001mfd yellow box cap. It is stamped 102 on the top. Solder into C18.
Locate the 0.01mfd yellow box caps. They are stamped 103 . Solder into C9, C10,
C11.
