Synthesis Technology E350 Morphing Terrarium, Руководство пользователя

Страница: 2 / 7

Controls and Jacks
1 - COARSE frequency control covers ~ 8 octaves
2 – FINE frequency control covers ~ 0.5 octaves
3 – FM amount. This is an attenuator for whatever is plugged into the FM jack (#10). The response is
exponential.
4 – MORPH X. This control sets the initial starting point for the wavetable XY OUT, as indexed in the
current ‘row’.
5 – MORPH Y. This control sets the initial starting point for the wavetable XY OUT, as indexed in the
current ‘column’.
6 – MORPH Z. This control sets the initial starting point for the wavetable Z OUT. It scans through all
64 waves in the selected bank. This is useful to ‘audition’ all of the waves in the selected bank.
7 – RANGE switch. Selects 3 different frequency ranges for the E350. The total range is 1 cycle in 13
minutes to 10KHz.
8 – BANK switch. Selects 3 different sets of 64 waves. Bank A has mostly sine waves in different
harmonic series and includes a few Hammond drawbars sets. Bank B is a wide assortment and includes
male/female vocal formants. Bank C is specifically designed for LFO/modulation waveforms, but can
also be used in the audio range. For a complete description, see the User Manual.
9 – 1V/OCT input. This sets the pitch tracking of the E350. There is factory trimmer for this setting
located beside the FINE pot on the first pc board.
10 – FM input. Can be DC to 8KHz, and is attenuated by the FM panel control.
11 – SYNC. A positive voltage exceeding 0.25V will place the E350 into hard sync (both outputs reset to
-5). In normal operation, another VCO is used to ‘drive’ sync.
12 – MORPH X. This voltage is added to the panel control to index the XY OUT wave along a ‘row’.
13 – MORPH Y. This voltage is added to the panel control to index the XY OUT wave up/down a
‘column’.
14 – MORPH Z. This voltage is added to the panel control to index the Z OUT wave for all 64
wavetables in the selected bank. It starts at Row 1, Column 1 (wavetable 1) and goes to Row 8 Column
8 (wavetable 64).
15 – XY OUT. This output (10V pk-pk) is a DC-coupled wave that is the result of all the MORPH X and
MORPH Y settings.
16 – Z OUT. This output (10V pk-pk) is a DC-coupled wave that is the result of the MORPH Z settings.
General Info
Inputs: -5V to +5V, DC to 8KHz.
Outputs: -5V to +5V, DC to 10KHz
Power: +12V@55ma, -12V @25ma. For MOTM use: +15V @45ma, -15V@ 15ma.
Jumper options: JP7 – Morphing Wavetables operation (OFF) Phase Shift Mode (ON)
JP8 - Interpolation Enabled (OFF) Interpolation Disabled (ON)