2
QSG Diode Pointer Ver 2.1
a Novanta company
Diode Pointer Quick Start Guide
Important
Notes:
Mounting:
4.
Insert the four screws into the front of the laser a few turns so that the threads are engaged. This allows
adequate clearance between the screw head and the laser’s front plate to hang the diode pointer.
Series 48 lasers manufactured after August 1998 provide a Diode Pointer power con-
nector on the faceplate. Some lasers require installation of the provided others, use the
supplied wall-plug transformer power supply.
5.
Once the pointer is ‘hung’ over the heads of the screws, assure access to both the near/ far field adjuster
screws accessible. Tighten the four screws with the ignition wrench.
4.1
Hanging the Diode Pointer onto the laser faceplate & providing power to the unit.
Warning
Serious
personal
injury
Do not stare directly into the red laser light emitted from the Diode Pointer OR
the laser. The light is intense enough to injure the eye with exposure.
Always wear eye protection!
CO
2
laser emits invisible laser radiation. Since direct or diffuse laser radiation
can inflict severe corneal injuries. Remain clear of the beam while performing
adjustments; direct or diffuse laser radiation can seriously burn human tissue.
Always wear safety goggles.
Always use shielded cable when connecting your PWM Command signal source
to PWM Positive/PWM Negative inputs.
Never stare into a laser beam!
ti-Series shown
