SynOptics SYNBIOSIS aCOLyte3, Руководство пользователя

Страница: 34 / 110

Creating a new batch
Adjusting the position and size of frames
The following sections describe how to adjust the position and size of frames:
l
Moving frames , below
l
Resizing frames , below
l
Rotating frames
, on the facing page.
Note You should load a plate from the batch into the instrument and capture an image before
adjusting the frame – see
Loading plates into the instrument , page 8, and Capturing an image ,
page 9.
Moving frames
To move a frame:
1. Move the pointer near to the center of the frame – an orange circular drag handle will
appear in the center of the frame. For example:
2. Drag the frame and drop it in the required position.
Resizing frames
Generally, frames should be made as large as possible within the area of the plate but
avoiding the very edge (as this may produce spurious results) and allowing some margin for
variation between plates. You can adjust the size for individual plates in Measurement mode,
but it will save time if you can use a single setting for all the plates in a batch.
To resize a frame:
1. Move the pointer near to the frame boundary (for Partial Plate frames, the frame
boundary is the circle of which the frame forms a sector).
28 aCOLyte3 User Manual