11
Chapter 2: Hardware Setup
To make sure FlashStation recognizes the new memory capacity:
1
Install DiskStation Manager (DSM). (See the next chapter for more information.)
2
Log in to DSM as
admin
or a user belonging to the
administrators
group.
3
Check
Total Physical Memory
in
Control Panel
>
Info Center
.
If your FlashStation does not recognize the memory or does not start up successfully, confirm that the memory is
installed correctly.
To remove the RAM Module:
1
Follow step 1 and 2 of the "To install the RAM module" section to shut down your FlashStation, disconnect the
cables, and then remove the bottom lid.
2
Push the levers on both sides of the memory module outwards. The module will be released from the slot.
3
Hold the memory module by its notches and remove it from the slot.
4
Replace the bottom lid. Replace and tighten the screws removed in step 1.
5
Reconnect the cables removed in step 1. Now, you may turn on your FlashStation.
