7
Chapter 2: Hardware Setup
b
Slide the 2.5" Disk Holder into the hard drive bay, and push it all the way until the hard disk is connected
to the SATA connector. Secure the Disk Holder with the provided screws.
3
Repeat the steps above to assemble the other hard disk you have prepared.
4
The disks' positions are numbered as shown below.
Note:
If you want to set up a RAID array, it is recommended that all installed hard disks are of the same size to
make the best use of hard disk capacity.
5
Replace the upper case, and tighten the screws on the back panel.
