11
5 Settings Menu
Introduction
The settings menu displays the current state of each GDR108
setting and allows you to change or adjust it. Settings can be
changed using the front panel of the Synapse frame (SFR18, SFR08
or SFR04) or with Cortex. Also the SCP08 control can be used.
Please refer to chapter 3 for information on the Synapse front panel
control and Cortex.
Note:
All items preceded with a #-sign are part of the presets.
SYSTEM SETTINGS
PLL_set_A
The GDR108 is capable of re-clocking a range of 3Gbit/s, HD and
SD SDI transport stream bitrates.
PLL_Set_A
is used to set the
input of the GDR108 to the correct bitrate of the incoming signal.
PLL_Set_A
can be set to
Auto
,
270 Mb/s
,
1485 Mb/s
and
2970 Mb/s
. The default setting is
Auto
.
Reclocker_A
The setting item
Reclock_A
determines if the incoming signal
will be reclocked by the GDR108. The settings are:
■
Auto
: Auto selection between
Bypass
and
Reclocked
.
■
Bypass
: Does not re-clock the incoming signal
■
On
: The GDR108 always attempts to re-clock the input
The default setting is
Auto
.
Mute_A
Mute_A
enables the input of the GDR108 to be muted. The settings
of
Mute_A
are
On
,
Off
,
Input Loss
or
PLL Unlock
. Set to
Input Loss
will mute the input only in case a carrier loss is
detected on the input. Set to
PLL unlock
will mute the input in
case the PLL rate is not available. The Default setting is
Off
.
HDMI
HDMI1-Format
Here you select the output format of the SFP HDMI output module.
Possible modes are:
■
RGB444
(default)
■
YCrCb422
■
YCrCb444
