Symmetricom GPS Antenna, Руководство по установке

Страница: 20 / 32

Assembly of the Antenna
Cable and the Connector
GPS Antenna Sets
5.2. Preparation of the Antenna Cable
Usually the connectors are assembled as follows:
Slide the hex nut, washer and gasket onto the antenna cable one by one.
Strip the antenna cable (inner conductor, dielectric, braid and jacket) as follows:
a
b
c
Combination cable - connector
a
jacket
strip length
b
conductor
strip length
c
braid
strip length
Connector for cable type RG58, straight 8,5 5,5 5,5
Connector for cable type RG213, straight 13 6,5 6,5
Connector for cable type RG213 and Low
Loss, angle
19,0 5,5 3
Connector for cable type LowLoss, straight 6,4 6 6
5.3. Assembly of the Connector
Place the braid clamp over braid and push back against cable. Fold back braid wire.
Slide ring and rear isolator against the braid clamp
Insert inner conductor of the cable into the contact and solder it.
Insert front isolator together with cable and parts into the main body, screw the hex nut
until it is tightened
14
001023AD – July 2003