565E
10
Rear Panel Overview
Chapter 6
Power -
The power cord plugs into the IEC
power receptacle on the rear of the 565E.
Connect the plug end of the power cord to an
appropriate source of AC power. Observe the
marked power supply voltage on the rear
panel.
B
ALANCED
/U
NBALANCED
I
NPUT
-
1/4-inch TRS phone jack.
This connector is wired in parallel with the XLR input
connector. Connect either balanced or unbalanced sources
here. Use a tip-sleeve plug for unbalanced sources and a
tip-ring-sleeve (stereo) plug for balanced sources.
B
ALANCED
I
NPUT
-
XLR-3 female connector. This connector
is wired in parallel with the TRS input connector. Use this
connector when you need a balanced XLR input.
B
ALANCED
/U
NBALANCED
O
UTPUT
- 1/4-inch tip-ring-sleeve
(TRS) phone jack, wired tip= high(+), ring =low(-) and
sleeve=ground. Use this jack when you need a 1/4-inch
balanced or unbalanced output. The nominal signal level
here is +4 dBu. The wiring diagram for the B
ALANCED
/
U
NBALANCED
O
UTPU
t connector is reproduced on the back
panel of the 565E.
Note
Connecting an unbalanced cable here will result
in an output level that is 6dB lower than the
output level you get if you use a balanced cable.
B
ALANCED
O
UTPUT
-
XLR-3 male connector, wired Pin 1=ground,
Pin 2=high(+) and Pin3=low(-). Use this connector when you need a balanced XLR output. The
nominal signal level here is +4 dBu. The wiring diagram for the B
ALANCED
O
UTPUT
connector is
reproduced on the back panel of the 565E.
Power Connection
Audio Output Connections
Sidechain/Key Input Connection
K
EY
I
NPUT
- 1/4-inch tip-ring-sleeve (TRS) phone jack, wired tip = return, ring =
send and sleeve = ground. To trigger the compressor, expander or limiter of the
565E from an external audio source, use a cord with either a TS or TRS connec-
tor. Connect the tip to the audio signal that you wish to use as a key/trigger
signal, and connect the sleeve to ground (if you use the TRS connector, make
no connection to the ring). To externally process the sidechain signal, use the
ring of this connector to feed the sidechain signal to an external processing
device, and use the tip as the return form the external processing device. The
wiring diagram for the K
EY
I
NPUT
connector is reproduced on the rear panel of
the 565E.
Audio Input Connections
AC INPUT
MAXIMUM
15 WATTS
FABRIQUÉ AUX E.-U. PAR SYMETRIX INC., LYNN
RÉFÉREZ TOUTE RÉPARATION À UN TECHN
CHANNEL 1 OUTPUT
BALANCED
UNBALANCED
BALANCED/
SIDECHAIN
INPUT
KEY
CHANNEL 1 INPUT
BALANCED/
UNBALANCED
BALANCED