Symbol PTC-870IM, Руководство пользователя

Страница: 21 / 72

the ARDIS radio or MicroRadio to the antenna
connector on the bottom of the unit.
Turning on the PTC-870IM
Press the On/Off button to turn on the PTC-870IM.
Running the power-on self test
When you turn on the PTC-870IM, it automatically
performs a series of self-diagnostic tests to ensure
it is operating correctly. The Power LED blinks for
approximately 5 seconds while the tests are being run.
If the Power LED does not light or the PTC does
not turn on after 5 seconds, the diagnostics have
discovered an error. Check the PTC’s connection to
AC or vehicle power and all other connections to the
PTC. Then attempt to turn on the PTC again. If the
error persists, refer to the “Troubleshooting” section
on
page 42 .
Checking the PTC-870IM
1. Make sure the PTC is turned on.
2. Look at the PTC’s display screen. What appears
on the screen depends on the program your
organization uses.
If the PTC is operating correctly, you should not
see a blank display screen or hear any beeps
warning you that an error has occurred.
Repeat the steps in this chapter if your
PTC-870IM is not operating properly. If the
problem persists, refer to the
“Troubleshooting”
section of this manual or contact the Telxon
Customer Support Center at 1-800-800-8010.
19