Symbol P360, Руководство по продукции

Страница: 71 / 198

5-1
Chapter 5
Parameter Menus
Introduction
This chapter has the optional parameter bar codes necessary to program the Phaser
memory scanner.
Operational Parameters
The Phaser memory scanner is shipped with the settings shown in Table 5-1 . These default
values are stored in non-volatile memory and are preserved even when the scanner is
powered down. You can change these default values by scanning the appropriate bar
codes included in this manual. These new values replace the standard default values in
memory. The default parameter values can be recalled by scanning the bar code in the
section Set Default Parameter on page 5-7.
The scanner automatically detects which cable it is attached to, either an RS-232 or a
Synapse cable. If it is attached to an RS-232 cable and has either an ICL, Nixdorf, or Fujitsu
host interface, then scan the appropriate bar code from page
5-11 after power up. Any other
host interface works with the default setting.
If it is attached to a Synapse cable, plug everything together as described on page 2-8 and
then follow the directions that come with the Synapse cable for setting up the host interface.