Symbol DS6707-DP20411ZZR - Symbol Digital Scanner DS6707-DP, Руководство по продукции

Страница: 69 / 402

Chapter 5 Imaging Preferences
Introduction
You can program the digital imager scanner to perform various functions, or activate different features. This
chapter describes imaging preference features and provides programming bar codes for selecting these features.
The digital imager scanner ships with the settings in Imaging Preferences Parameter Defaults on page 5-2 (also
see Appendix A, Standard Default Parameters for all host device and miscellaneous defaults). If the default values
suit requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the digital imager scanner.
If not using a USB cable, select a host type after the power-up beeps sound. See Chapter 6, SSI Interface , Chapter
7, USB Interface and Chapter 8, RS-232 Interface for specific host information. This is only necessary upon the
first power-up when connecting to a new host.
To return all features to default values, scan the Set Default Parameter on page 4-4 . Throughout the programming
bar code menus, asterisks (
*
) indicate default values.
NOTE
Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
Feature/Option
*
Indicates Default
*
Enable Decode Aiming Pattern
(02h)
Option Hex Value
for programming
via SSI command