symbios logic J21971S-0398, Руководство по установке

Страница: 26 / 86

Installing the Rackmount Command Module
Mount the Command Module in the Cabinet
16 MetaStor Command Module Installation Guide Revision A, March 1998
Mount the Command Module in the Cabinet
Tools/Equipment
Screwdrivers and all command module CRUs
Instructions
Use this procedure to install a rackmount command module chassis
on the support rails in a Data Center cabinet.
1
Put the command module in the cabinet ( Figure 7 ).
At the front of the Data Center cabinet, set the command module on the
support rails and slide the module into the cabinet.
Important Note To make cable installation easier, you can slide the command
module slightly toward the back of the cabinet and attach all the
SCSI cables before securing the command module to the rails. If you
want to do this, refer to
“Connect the Interface Cables” on page 18
before performing Step 2 of this procedure.
2
Secure the command module ( Figure 7 ).
Align the front holes on each side of the module with the first holes on
front of the support rails. From the inside of the chassis, insert 6-32 x
3/8 screws through the chassis and into the first holes in the support
rail.
CAUTION Electrostatic charge can damage sensitive components. Use a
grounding wrist strap or other antistatic precautions before
handling any components in the cabinet.
3
Are you connection this command module to a SCSI or Fiber
Channel host?
●
SCSI host. Go to Step 4 .
●
Fiber Channel. Go to Step 5 .