symbios logic J21971S-0398, Руководство по установке

Страница: 17 / 86

Preparing the Data Center Cabinet
Prepare the Cabinet
Revision A, March 1998 Installation Instructions 7
4 Install the support rails.
Make sure that the support rails are level before installing them in the
cabinet. You can count the cabinet rail holes (from top or bottom) to
find the correct position, then attach each support rail as follows:
a Facing the front of the cabinet, hold the first support rail
inside the cabinet so the mounting bracket holes align with
the holes in the cabinet rail (
Figure 3 ). Insert a 10-32 x ½
screw through the cabinet rail and into the middle hole on
the support rail. Attach the second support rail to the front
of the cabinet on the opposite side.
b Facing the back of the cabinet, align the holes in the support
rail with the holes in the back cabinet rail. Make sure that the
support rail is level. Insert three 10-32 x ½ screws through
the cabinet rail and into the bracket in the support rail.
Attach the second support rail to the back of the cabinet.
c
On the front of the cabinet, install screws in the top and
bottom holes of both support rail brackets.
d If you are installing additional modules (command or drive)
in this cabinet, repeat
Step a through Step c to add more
support rails. When you are finished, go to “Set the Drive
SCSI IDs” on page 8 .
Figure 3 Installing Rackmount Rails
End of Procedure
!
!
!