This fixture is compatible with 0-10V output dimming controls. Using the 0-10V dimming the light output will range from 10% - 100%. To get to 0%
light output (OFF) it is necessary to disconnect the input power from the LED drivers. This can easily be done by inserting a relay/switch between
the line and load connectors inside the fixture. Connect dimmer or wall switch to dimming inputs on driver. (See Wiring Diagram below)
Sensor Wiring
Diagram
CLEANING AND MAINTENANCE
•To maintain the fixture efficacy occasional cleaning of the outer lens surface may be needed.
•Use a mild soap or detergent, which is essentially neutral pH (pH approximately 6 to 8), nonabrasive, and
which contains no chlorinated or aromatic hydrocarbons.
•Wash thoroughly, using a soft cloth.
•Rinse with clean, cold water and wipe dry.
TROUBLE SHOOTING CHECKLIST: If luminaire does not work
– Check your power source.
– Check electrical connections.
Ceiling Mount
•Attach U-bracket using four supplied screws into pre-tapped holes in the top of the housing
•Mark the desired mounting location with chalk. Using a drill, drill holes on the marked locations (Figure 9).
•With the help of a hammer, add the included expansion screws (Figure 10).
•Align the holes on the bracket with expansion screws (Figure 11) and move the luminaire into place.
Tighten the nuts to complete the installation of the luminaire (Figure 12).
•After completion, please wire in accordance all local regulations. Once the installation and wiring are
complete, the luminaire can be adjusted up to 50 degrees by adjusting the screws connected to the
bracket accessory (Figure 13).
ADDING A BOTTOM LENS (Sold separately):
1. Remove bottom lens and clamp screw from packaging
2. Place lens over opening of refractor and place clamp over lens and refractor rim. Place screw through hole in clamp and tighten clamp to secure.
Clamp
ADDING A LINE VOLTAGE SENSOR OR DIMMER (provided by others):
Line Voltage Sensor
Black
Line
White
Neutral
Green
GRD
Dimming
+ -
Black
Line
White
Neutral
Green
GRD
DIM+
P/B
DIM-
G/W
Black
Line
White
Neutral
Green
GRD
DIM+
P/B
DIM-
G/W
Dimmer Wiring
Diagram
TROUBLE SHOOTING CHECKLIST: If luminaire does not work
3597711
C
on
n
ec
t
to
AC
Po
w
er
Li
ne
N
eu
tr
al
L
o
ad
LED
D
riv
er
C
on
n
ec
t
to
AC
Po
w
er
LED
Dr
iv
er
C
on
n
ec
t
to
D
im
m
er