11
OPERA
TING
THE PLASMA DISPLA
Y
POWER
INPUT SELECT
DISPLAY
VOL
MUTE
SCREEN MODE
STILL
INPUT SELECT
DISPLAY
SELECTING THE INPUT SIGNAL
The procedure for selecting the input signal
described here is for use with the remote control.
However, the
INPUT SELECT
button on the plas-
ma display can also be used in the same way.
Displaying the Current Input Signal
1
Press the
DISPLAY
button.
The name of the current input terminal is dis-
played on the screen.
2
To clear the name of the current input terminal,
press the
DISPLAY
button again, or wait for
approximately 4 seconds.
NOTE:
• To redisplay the name of the input terminal, press
the
DISPLAY
button again.
Selecting the Input Signal
1
Press the
INPUT SELECT
button to select the
input signal.
Each time you switch the input signal, the
name of the selected input terminal is dis-
played on the display for approximately 4 sec-
onds.
The
INPUT SELECT
button cycles through the
input terminals in the following pattern:
NOTE:
• When switching the input signal, audio mute turns
ON temporarily.
• S-VIDEO1 takes preference over the VIDEO 1
jack, as does S-VIDEO 2 over the VIDEO 2 jack.
Therefore, if there is input to the VIDEO and S-
VIDEO terminals at the same time, the S-VIDEO
signal is displayed on the screen. If the S-VIDEO
cable is not connected to the plasma display, the
VIDEO signal will be displayed on the screen.
• 480i (interlaced) signals can be connected to the
COMPONENT 1 and 2 terminals. Any of the fol-
lowing display formats: 480i, 480p (progressive),
1080i, and 720p (progressive) signals can be con-
nected to the COMPONENT 2 terminal. If one of
these video signals is detected, the format of the
input signal is displayed after the name of the cur-
rent input terminal, as in the following manner.
• A "No signal" message appears if there is no video
signal, and there is no message currently dis-
played on the screen for volume adjustment or the
setup menu, etc. If there continues to be no video
signal for more than 10 seconds, "No signal" slow-
ly moves around the screen.
• If there is no video signal, and there has been no
operation from the remote control or the buttons
on the main unit for more than 15 minutes, the
auto shut-off function activates, and the display
switches to standby mode.
Video 1
(S-Video 1)
Video 2
(S-Video 2)
Component 1
Component 2