4
FIREPLACE INSERT INSTALLATION
The fireplace insert can be installed after the mantel has been fully assembled.
WARNING:
Make sure the fireplace insert controls are in the OFF position and the
unit is NOT plugged in.
Step 1: Carefully place the INSERT in the unit opening. The front of INSERT should be
flush with the front of the mantel. Carefully lift the INSERT into the mantel until the
top stopper is against the mantel.
Step 2: Attach 3 Mounting Clips [U] to the top side of insert with 3 Short KD screws [T].
Attach 2 Mounting Brackets [V] to the bottom of insert with 2 Short KD screws [T]. See
Fig F.
Fig. F
Step 3: Move assembled unit to desired location. Unit should not be positioned in area
exposed to direct sunlight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you
may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace in-
sert has been properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the 2 front covers at the top right and left corners of
the insert, and can be accessed by gently pushing the bottom of the covers.
O/I:
Press this button for main power and flame effect. The indicator light will turn on.
See below for other control switches.
750W:
For low heat function - Press this switch while the
O/I
switch is in the on
position for low heat. The indicator light will turn on.
1500W:
For high heat function - Press this switch while the
O/I
switch and the 750W
switch are in the on position for high heat. The indicator light will turn on.
Temperature Control:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired tem-
perature and to the left for lower temperature. This temperature control dial can only
be used while the
O/I
switch and 750W & 1500W switches are in the ON position.
Dimmer Control Knob:
Turn the dimmer dial clockwise or counter clockwise to get
the desired flame intensity. The dimmer switch can only be used when the
O/I
switch
is in the on position.
Note:
When the
O/I
switch is turned off, all other heater functions will stop even
though the switches may be in the on position.
MAINTENANCE
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off the
unit and removing the light bulbs to avoid the accidental burning of the skin.
risk OF FirE: dO NOt ExcEEd tHE rEcOMMENdEd bulb wattagE.
REPLACING THE FLAME EFFECT LIGHT
AND LOG-SET LIGHT BULBS
Step 1: Remove the 2 screws on the front of the fireplace and open the glass window.
Step 2: Remove the screws from both sides of the log set bed.
Step 3: Remove the log set bed. You will find 2 x 40 Watt type E-12 bulbs.
Step 4: Loosen, remove and replace the burnt out bulb(s)
Step 5: Set the log set bed back into place and re-attach the screws.
Step 6: Close the glass window and re-attach the screws.
Step 7: Plug in the unit.
