Sylvania SOQCM769D-40COO, Инструкция по эксплуатации, Страница: 3 / 5

3
MAINTENANCE WARNING:
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off
the unit and removing the light bulbs to avoid the accidental burning of the skin.
RISK OF FIRE: DO NOT ExCEED THE RECOmmENDED BULB WATTAGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 4 screws on the back of fireplace and remove the rear cover
of the unit.
Step 2: You will find 1 X 60W Type B-10 bulb under log-set bed.
Step 3: Loosen and remove burnt out bulb and replace with new bulb.
Step 4: Close the rear cover and secure with the 4 screws.
Step 5: Plug in the unit.
SELF REPAIR SET
Touch-up repair paint
1. Paint directly on the mantel unit if necessary. fig. A
fig. A
If any problems are found with the original parts during mantel assembly such as the
panels cannot be installed with the plastic connector. Try to solve by one of the
following methods.
Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
Pencil, Hammer, Philips Screwdrivers, Safety Goggles and gloves (if necessary).
WARNING: WEAR GOGGLES WHEN USING POWER TOOLS.
Option 1: Use the spare KD NUTS, KDSCREWS and PLASTIC CONNECTOR
1. Place the PLASTIC CONNECTOR on the mantel unit and mark the drill-holes as
shown in fig. B.
fig. B
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm) on
the mantel. Each Plastic Connector needs 3 holes. See fig. C.
fig. C
3. Gently install the KD NUTS into the drilled-holes with hammer as shown in fig. D.
fig. D