3
MAINTENANCE WARNING
Disconnect power and unplug the power cord before attempting any maintenance
or cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs
in your unit can become extremely hot. Allow at least 10 minutes between turning
off the unit and removing the light bulbs to avoid the accidental burning of the skin.
riSK OF FirE: DO NOt ExcEED tHE rEcOMMENDED BUlB WattaGE.
REPLACING THE FLAME EFFECT LIGHT
AND LOG-SET LIGHT BULBS
Step 1: Remove 12 screws on the back of fireplace and open the rear cover.
There are 2 larger screws and 10 smaller screws
Step 2: You will find 1 X 40W Type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2 larger screws into the top left corner hole
and bottom right corner holes as shown in the diagram. Secure the 10
smaller screws into the remaining holes. Make sure the screws are in the
correct holes and have been tightened.
Step 5: Plug in the unit
REPAIR SET
TOUCH-UP REPAIR PAINT
1.Paint directly on the mantel unit if necessary. Fig. A
Fig. A
REPAIRS
If any problems are found with the original parts during mantel assembly such as
the panels cannot be installed with the plastic connector. Try to solve by one of the
following methods.
Tools required:
Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
pencil, hammer, Philips screwdriver, safety goggles and gloves (if necessary).
WarNiNG:
Wear goggles before you start drilling.
OptiON 1:
Use the spare KD NUTS, KD SCREWS and PLASTIC CONNECTOR
1. Place the PLASTIC CONNECTOR on the mantel unit and mark the drill-holes as
shown in Fig. B.
Fig. B
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm) on
the mantel. Each Plastic Connector needs 3 holes. See Fig. C.
Fig. C Fig. D
