6
Fig. S
WARNING:
Ensure the safety cable is attached to the back of the unit to avoid
tip over.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electrical outlet, it is
ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed
by pulling the grill from the top, forward and down.
0/I:
Press this button for main power and flame effect. The indicator light will be on.
See below for other control switches.
1250W:
For heat function - Press this switch while the 0/I switch is in the ON position.
The indicator light will be ON.
Temperature Control:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired
temperature and to the left for lower temperature. This temperature control dial can
only be used while the 0/I switch and 1250W switches are in the ON position.
Note:
When the O/I switch is turned off, all other heater functions will stop even
though the switches may be in the on position.
MAINTENANCE
MAINTENANCE WARNING:
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off
the unit and removing the light bulbs to avoid the accidental burning of the skin.
RISK OF FIRE: DO NOT ExCEED ThE RECOMMENDED BuLB WATTAGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 12 screws on the back of fireplace and open the rear cover. There are
2 larger screws and 10 smaller screws.
Step 2: You will find 1 x 40W Type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the larger screws into top left corner hole and
bottom right corner holes as shown in the diagram. Secure the 10 smaller
screws into the remaining holes. Make sure the screws are in the correct
holes and have been tightened.
Step 5: Plug in the unit.
REPAIR SET