6
unit is NOT plugged in.
Step 1: Carefully place the INSERT in the unit opening. The front of INSERT should
be flush with the front of the mantel. Carefully lift the INSERT into the mantel until
the top stopper is against the mantel.
Step 2: Attach 3 Short KD screws (U) at the top of insert and attach the L-mounting
bracket to Base panel with 2 Short KD screws. See Fig Q
Fig. Q
Step 3: Move assembled unit to desired location. Unit should not be positioned in
area exposed to direct sunlight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electrical outlet, it is
ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed
by pulling the grill from the top, forward and down.
O/I:
Press this button for main power and flame effect. The indicator light will turn
on. See below for other control switches.
1250W:
For heat function - Press this switch while the
O/I
switch is in the ON posi-
tion. The indicator light will turn ON.
Temperature Control:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired
temperature and to the left for lower temperature. This temperature control dial can
only be used while the
O/I
switch and 1250W switch are in the ON position.
Note:
When the
O/I
switch is turned off, the heater functions will stop even though
the switches may be in the ON position.
MAINTENANCE
MaiNtENaNcE warNiNg:
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off
the unit and removing the light bulbs to avoid the accidental burning of the skin.
risk OF FirE: dO NOt ExcEEd tHE rEcOMMENdEd bulb wattagE.
REPLACING THE FLAME EFFECT LIGHT
AND LOG-SET LIGHT BULBS
Step 1: Remove 12 screws on the back of fireplace and open the rear cover.
There are 2 larger screws and 10 smaller screws
Step 2: You will find 1 X 40W Type B-10 bulbs under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2 larger screws into the top left corner hole
and bottom right corner holes as shown in the diagram. Secure the 12
smaller screws into the remaining holes. Make sure the screws are in the
correct holes and have been tightened.
Step 5: Plug in the unit