2
WARNING: THE HEATER MUST BE INSTALLED BY A CERTIFIED
ELECTRICIAN AND IN ACCORDANCE WITH ALL LOCAL AND NATIONAL
ELECTRICAL CODES. ALL ELECTRICAL CONNECTIONS MUST BE MADE
INSIDE THE JUNCTION BOX AT THE BACK OF THE UNIT.
This heater has lead wires spliced at both ends connected with twist-on wire
connectors. Either end can be connected to the power supply (with a thermostat
or switched controller - not included).
CAUTION: TURN OFF MAIN POWER BEFORE BEGINNING INSTALLATION
TO AVOID ELECTRIC SHOCK.
1. Loosen screws to remove the cover from the back of the heater.
2 . Remove the twist-on wire connector of lead wires.
3 . Strip wires and connect supply wires to the heater lead wires.
LIVE - Black lead
GROUND (NEUTRAL) - White
Place twist-on wire connectors over the electrical connections.
4 . Connect the grounding wire to the grounding terminal (marked GND) and
tighten the provided screw.
5 . Place all wires inside the junction box and replace the cover.
6 . Push wiring into the wall as you position the baseboard heater against the wall.
7. Once the heater is in position, attach the screws through the pre-drilled holes,
ensuring it fits firmly against the wall to ensure quiet operation. Minimum 4
screws required.
Screw holes for wall mounting
OPERATION
Adjust the wall thermostat (not included) to increase or decrease the
temperature setting.
MAINTENANCE
Warning: To reduce the risk of fire or electric shock, always switch off the unit and
wait 10 minutes to allow it to cool before attempting any maintenance or cleaning.
It is recommended that the heater is cleaned periodically, in order to avoid dust
blocking the grill and allow ventilation.
CLEANING
Wipe the unit with a soft damp cloth. Do not use abrasive cleaners or spray liquids
on the unit surfaces.
Note: It is possible that the unit surface may discolour (yellow) over time, due to
dust or cigarette smoke. This is normal and not a manufacturing defect.
