2
IMPORTANT:
Please note when you open the carton carefully check the unit and make sure there
are no damages. If you have any problems with the unit, with how the various
functions work or with hidden damages or missing parts, please call:
1-800-459-
4409 (EST) for customer service. NOTE: DO NOT RETURN UNIT TO THE STORE
BEFORE CALLING THE TOLL FREE NUMBER. Do not dispose of your packaging
cartons until you are completely satisfied with your new electric fireplace
heater. Read all instructions thoroughly before operating your new electric
fireplace heater.
NOTE:
Light bulbs may become loose during shipping. If the flame effect is dim or
does not work, please check that light bulb or bulbs are finger tight in socket. See
instructions for replacing bulb or bulbs.
NOTE:
The electric fireplace heater may emit a slight harmless odor when first turned
on. This is caused by activating the internal heater components for the first time and
should not occur again.
ASSEMBLY INSTRUCTIONS
PARTS LIST
Z. WALL ANCHOR SAFETY CABLE
Wall Anchor ......................................................................................................................... 1
Screw for wall anchor ....................................................................................................... 1
Screw for mantel ............................................................................................................... 1
Safety cable ........................................................................................................................ 1
CAUTION:
Carefully move the assembled unit to the desired location. The fireplace
mantel should not be positioned in an area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of wall anchor safety cable is highly recommended in order to reduce the
risk of the fireplace being tipped over accidentally. WARNING: This cable may reduce
possible risk of injury if the fireplace is improperly handled, but is not a substitute for
proper adult supervision. Children should not be left unattended near any heater.
1. Drill a 5/16” (8 mm) hole in the wall. Insert the plastic wall anchor into the hole and
gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantel close to the wall.
3. Attach the safety cable to the mantel using the screw for mantel. See fig. A and B.
4. Use the screw for wall to attach the other end of safety cable to the wall.
5. Make sure all screws are tight.
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 watts. Once the fireplace
insert has been properly connected to a grounded electrical outlet, it is ready to
operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
0/I:
Press this button for main power and flame effect. The indicator light will be on.
See below for other control switches.
1250W:
For heat function - Press this switch while the 0/I switch is in the ON position.
The indicator light will be ON.
Temperature Control:
To adjust the temperature to your individual requirements,
turn the temperature control dial to the right (clockwise) to increase the desired
temperature and to the left for lower temperature. This temperature control dial can
only be used while the 0/I switch and 1250W switches are in the ON position.
Note:
When the O/I switch is turned off, all other heater functions will stop even
though the switches may be in the on position.
fig. A
fig. B