Sylvania 42MF439B, Руководство по обслуживанию

Страница: 29 / 105

7-1 A91H1FW
FIRMWARE RENEWAL MODE
Equipment Required
a. USB memory
b. Remote Control Unit
Firmware Update Procedure
Note: There are two states (the User Upgrade and
the Factory Upgrade) in firmware update.
The identification of User Upgrade and Factory
Upgrade are done by the filename.
1. Turn the power off and unplug the AC Cord.
2. Insert the USB memory to the USB port as shown
below.
3. Plug the AC cord in the wall outlet and turn the
power on.
4. The update will start and the following will appear
on the screen.
Note: If the above screen isn’t displayed, repeat from
step 1.
The appearance shown in *1 is described as follows.
5. When the firmware update is completed, the
following will appear on the screen.
Unplug the AC cord and kindly remove the USB
memory from the USB port. Plug the AC cord in
the wall outlet again and turn the power on.
Note:
When the Factory Upgrade is used, after
restarting TV, shift to initial screen menu in service
mode. "INITIALIZED" will appear on the upper
right of the screen. "INITIALIZED" color will
change to green from red when initializing is
complete.
User Upgrade Upgrade the firmware only.
The setting values are not
initialized.
Factory upgrade Upgrade the firmware and
initialize the setting values.
Rear Cabinet
USB port
USB Memory
Software upgrade in progress. Please wait.
Do not remove the USB device or turn the TV off
while upgrade is in progress.
Software Upgrade
Downloading...
0%
*1
Appearance State
Downloading...
Downloading the firmware from
the USB memory.
Writing...
Writing the downloaded firmware
in flash memory.
Checking... Checking the new firmware.
Software Upgrade
The software upgrade is completed.
Remove USB storage device, unplug and replug power code.