SYCLOPE electronic HYDRO'Com HYD 7000, Инструкции по установке и вводу в эксплуатацию

Страница: 25 / 36

Presentation and programming Page 25/36
Installation and commissioning instructions manual
8) Programming analogue input
First, the user must choose the type of temper ature measurement: “Air temperature” or “Water
temperature”. Then, the corresponding programming window appears:
The user must enter the following parameters:
• The number of decimal after the comma must be defined according the choice of the user for
displaying the measured value.
• “Value for 4mA” corresponds to the minimum value read by the temperature sensor.
• “Value for 20mA” corresponds to the minimum value read by the temperature sensor.
• “Set point” is the temperature value wishes par the user.
• “ Direction ” is the direction of the process for adjusting temperature.
•
“Associated relay” corresponds to the output relay where the heater is located.
• “Max. duration” correspond to the maximum of time when the relay is engaged.
When all the values are entered, the user
must record the programming by pressing “Program” key.
9) Programming of the time schedule
First, the user must choose a function affected to the calendar and he associates a relay output.
Then, select each period of time for each day of the week.
When the green mark is on, the relay output affected to the timer is activated during the current
thirty minutes.