SY-HDBT-100T / SY-HDBT-100R
www.sy.co.uk
RS-45 Wiring
Both connectors must be wired identically.
HDBT will not pass through any Ethernet device, the HDBT-100T HDBT port must be connected directly to
the HDBT-100R HDBT port.
The two Ethernet ports act as a distributed four-port hub, with two ports located at the HDBT-100T
position and two at the HDBT-100R position. These Ethernet ports can be connected to any other Ethernet
device, including Internet access points.
Safety Instructions
To ensure reliable operation of these product as well as protecting the safety of any person using or
handling these devices while powered, please observe the following instructions.
1.
Use the power supplies provided. If an alternate supply is required, check Voltage, polarity and
that it has sufficient power to supply the device it is connected to.
2.
Do not operate either of these products outside the specified temperature and humidity range
given in the above specifications.
3.
Ensure there is adequate ventilation, as these products generate heat while operating.
4.
Repair of the equipment should only be carried out by qualified professionals as these products
contain sensitive devices that may be damaged by any mistreatment.
5.
Ensure that these products operate in a dry environment. Do not allow any liquids or harmful
chemicals to come into contact with these products.