Practice with your electric scooter as a PUSH SCOOTER until you feel comfortable riding
without the speed of the electric motors. Therefore its important turning the scooter „ON“
before practicing although you don‘t use the motor!!! Grasp the foam grips on the handle
bars with both hands, place one foot on the Deckboard, and push-off a few times with
your other foot to move forward.
Practice Starting the Drive System:
Your electric scooter has a unique power-saving, safety feature that ensures that the
electric motors do not engage until the vehicle is traveling in excess of 3 m.p.h.
To Accelerate:
When you are ready to accelerate, use your right thumb to gently squeeze the speed
controller trigger located at the right-hand grip. Your electric scooter electric motors are
now engaged. Gently continue squeezing the speed controller trigger until you attain the
desired speed. In order to go slower just release the speed control and your scooter will
slow down immediately.
Practice riding your Transporter on a flat safe area. Go slowly and practice acce
lerating, decelerating, and braking. Do not go any faster than your skills allow.
ALWAYS WEAR AN APPROVED SAFETY HELMET AND OTHER SAFETY GEAR WHEN
RIDING YOUR ELECTRIC SCOOTER.
Braking System:
THIS SECTION DESCRIBES BOTH AVAILABLE BRAKING SYSTEMS! PLEASE READ
CAREFULLY!
To Decelerate:
While riding your electric scooter with the electric motors engaged, release the speed
controller trigger and the unit will coast. You can then engage available braking systems.
Braking System: Pull the right hand brake lever to engage the rear brake. Pull the left
hand brake lever to engage the front disc brake.
Speed Control System
The scooter can be operated in two different speed levels. In the high speed mode the
scooter accelerates to full speed that is up to 40 km/h. The low speed mode can be confi-
gured and limited individually - e.g. at 6 km/h, 12 km/h or max. 20 km/h - just as you would
like to have it. The limitation of the speed function works as follows:
1. Turn on the scooter by pressing the red „ON / OFF“ button - LCD display turns on
2. Press the „MODE“ button on the speedometer until the scooters SLOW speed
mode is indicated by showing „SLO“ in front
of the displayed speed
3. Press the buttons „ON / OFF“ and „MODE“ simultaneously for about
2 seconds until the display jumps to the setup
menu.
4. Press the „ON / OFF“ button until you reach the menu point called P15
On / OFF-
switch
Throttle
INSTRUCTIONS
SXT-SCOOTERS
7
