MODEL 3000-STDX, 3000-LX / WAND OPERATION / PAGE 4 OF 4
Страница 1: ...be extended to its maximum length The sensor must also be swiveled from the stowed position to the 90 read position Next slide the depth probe up through the 1 4 hole in the back of the sensor swivel and screw the threaded end of the probe into the sliding collar Raise or lower the depth probe using the collar until the probe allows the sensor to rest at the desired depth from the stream bottom To...
Страница 2: ...sen the set screw and remove the entire rotor assembly when not using the Model 3000 Always replace the batteries in the Model 3000 Indicator with fresh ones 1 During rough use check the propeller frequently for frayed leading edges and for cracks Chipped or cracked props should be replaced Frayed leading edges can be brought back to acceptable levels of operation by reshaping them with 150 grit o...
Страница 3: ...zing should cause no significant loss of efficiency 6 Periodically examine the Thrust Bearing Nut 2100 A23 and check inside on the bottom the bearing surface If a pronounced cup begins to form wear from the ball shaped end of the Rotor Shaft the 2100 A23 should be replaced This is especially necessary when using the Model 3000 in low flow situations 2 FPS or lower 7 The Photo Optics in the sensor ...
Страница 4: ...MODEL 3000 STDX 3000 LX WAND OPERATION PAGE 4 OF 4 ...
