Operating the Walkie−Talkies
69
Scanning for a channel
Signals are searched for on all eight channels and all CTCSS co-
des in a continuous cycle.
SC
appears in the display. Channel scan-
ning is stopped if radio communication is found.
Press the
P
button to enable radio communication on this
channel. The walkie−talkie is set to the channel and channel
scanning is ended.
If you do not press the
P
button, channel scanning is resumed
five seconds after no further signal has been transmitted on this
channel.
Starting channel scanning
5 x
Activate the programming mode
+
Start channel scanning
The scanning routine stops at every channel on which a signal is
received regardless of the CTCSS/DCS code transmitted with the
signal.
Resuming channel scanning
+
Resume scanning for a channel
Scanning the CTCSS codes
6 x
Activate the programming mode
+
Scan the CTCSS codes
The scanning process stops when a signal with a CTCSS code is
transmitted on the set channel.
Scanning the DCS codes
7 x
Activate the programming mode
+
Scan the DCS codes
The scanning process stops when a signal with a DCS code is
transmitted on the set channel.
Stopping channel search
P
End channel scanning