switel WT118, Руководство по эксплуатации

Страница: 44 / 52

- Operation -
44
Press the MODE button briefly once. The current call code will flash
in the display. A new code between 00 and 38 can now be selected
using the
CHANNEL + and – buttons. If the code 00 is selected, all
calls will be signalled on the selected channel.
Walkie-Talkie 1 Walkie-Talkie 2
Note: The channel selected and the call code must correspond in
order for you to be able to talk to one another.
3.3 Calling another subscriber
When you want to talk to other subscribers, proceed as follows:
The two walkie-talkies must be switched on and set to the same
channel.
Press the small CALL button on the left-hand side. A ringing tone will
sound on the called unit for two seconds. Now wait until the person
called answers.
To speak yourself, press the TALK button. Hold the unit about 5 cm
from your mouth and speak in a normal voice. When you have
finished, release the
TALK button. The person you are speaking to
will hear a signal tone (Roger Beep) when you release the TALK
button. This will indicate to the other subscriber that you have finished
speaking and are waiting for a reply.
The volume of the incoming call signal depends on your volume
setting. Eight volume levels can be set using the
VOL- and VOL+
buttons. The selected volume will be shown in the display for 2
seconds. After this the display will revert to the channel setting.
CH CTCSS
ƈ
CH CTCSS
ƈ