11
Page
Version 1.3 October 2020
Figure 5
Close the battery door. Make sure the gasket (around the battery compartment) is properly seated in its trace
prior to closing the door. Tighten the set screw.
Note:
Do not install the batteries backwards. You can permanently damage the sensors.
The solar panel
does not charge the batteries, so rechargeable batteries are not needed or recommended.
Note:
We recommend installing Lithium AA batteries for sensors.
The sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds thereafter. Each time it
flashes, the sensor is transmitting data.
Replace the battery door and push to tighten it.
Note:
If the sensor does not power up after inserting the batteries, press the reset button shown in Figure
6.
