BOOT
CABLE
CABLE CLAMP
COUPLING RING
CORD CONNECTOR
STEP 2:
FEED THE FREE END OF CABLE THROUGH BOOT, CABLE CLAMP,
AND COUPLING RING IN THE ORDER SHOWN.
NOTE: CUT-OFF END OF BOOT FOR LARGER THAN 0.280"
DIAMETER CABLES.
STRIP CABLE END AND CONDUCTORS AS SHOWN.
CRIMP CONDUCTORS TO CONTACTS.
USE CRIMP HAND TOOL EN3CR OR PNEUMATIC CRIMP TOOL
EN3CRAUTO WITH #26 POSITIONER EN3POS26.
INSERT CONTACTS TO CONNECTOR HOUSING PER CONTACT
ARRANGEMENTS AND INSERTION INSTRUCTIONS.
CRIMP
CUT-OFF END OF BOOT HERE FOR
LARGER THAN 0.280" DIA. CABLES
EN3™ SERIES FIELD ASSEMBLY INSTRUCTIONS FOR CRIMP CONTACTS:
CONTACTS
STEP 3:
ALIGN TABS OF COUPLING RING WITH NOTCHES OF
CORD HOUSING AND PUSH COUPLING RING ONTO
CORD HOUSING.
STEP 4:
ALIGN CABLE CLAMP AND PUSH FORWARD UNTIL IT
SNAP-LOCKS ONTO THE REAR OF CONNECTOR HOUSING.
TURN NUT OF CABLE CLAMP COUNTERCLOCKWISE
UNTIL CABLE CLAMP TIGHTENS AGAINST CABLE.
STEP 5:
PUSH BOOT ALL THE WAY FORWARD, OVER
CABLE CLAMP, UNTIL FRONT END OF BOOT
SEALS TIGHTLY ONTO CONNECTOR HOUSING.
.75 19.1
.156 4.0
CABLE
CONDUCTOR
CONTACT
LOCKING DISC
CORD HOUSING
INSERTION
HAND TOOL
TYPICAL CONTACT INSERTION INSTRUCTIONS:
PLACE CONTACT IN GROOVE OF INSERTION HAND TOOL
EN3INS26
. NOTE: TIP OF TOOL SHOULD BE UP AGAINST
THE SHOULDER OF CONTACT.
INSERT CONTACT INTO CORRECT CAVITY OF CONNECTOR
BODY BY APPLYING CONSTANT PRESSURE UNTIL
CONTACT BOTTOMS UP AGAINST LOCKING DISC.
NOTE: DO NOT TILT TOOL DURING THE INSERTION.
REPEAT ABOVE PROCEDURE TO INSERT ALL CONTACTS
PER CONTACT ARRANGEMENTS.
CORD WIRING SIDE VIEW
NOTCH,
PIN #1 INDICATOR
CABLE CLAMP WITH NUT
IN POSITION
CABLE CLAMP
NUT
STEP 1:
PRESS THE TWO WINGS OF CABLE CLAMP INWARD, THEN THREAD NUT CLOCKWISE ONTO CABLE CLAMP
TO THE POSITION SHOWN.
