Usage
1. Power the light
●
By DC input cable
(1) Pls Make sure the light is switched off (turn the switch to “
〇
”). Plug the pole end of S-7104 into the DC-IN socket. Plug the D-tap end of
S-7104 to the camera auxiliary power tap or the battery’s D-tap output socket, which the voltage and power meet the requirements of
S-2060 LED light.
(2) For third-party DC cables, please make sure the DC connector is 5.5/2.1mm pole and input voltage should be 11-17V; and inner: positive,
Outer: negative. (Fig 3)
2. Fix the LED light to the camera
●
By 1/4”screw mount
(Fig 4)
With the supplied screw mounting base, the S-2051 can be directly installed on 1/4” thread handle.
●
By Cold shoe
(Fig 6-Fig 8)
(1) Unscrew the 4 screws and take down the 1/4” bolt base from the light.
(2) Install the supplied cold shoe base onto the light.
(3) Anticlockwise revolve the fasten knob, and loose the cold shoe slice, then install onto the camera cold shoe slot, and fasten the knob to
finish.
3. Adjust the S-2051 angle:
Hold the light, and adjust the light upward or downward.(Fig 5)
4. Open barn doors and filters:
Open the barn doors and filters to about 45°. (Fig 1)
5. Switch on:
Turn the switch to “ I ”.
6. Adjust the Illuminance:
Adjust the Illuminance from 10% to 100% by the dimmer.
7. Adjust color temperature:
Output 5600K light by using 5600K filter (see Fig 1.1); Output 3200K light by using 3200K filter (see Fig 1.3)
Fig 3
Fig 6
Fig 7
Fig 8
Fig 4
Fig 5
pole plug
Hold the light
Adjust upword
or downword
