HR
Blood
BP
Heart Rate
This interface automatically turns on heart rate measurement. At the same time,
the green light of PPG at the inner side is turned on and the measurement begins.
Value will be measured in 30 to 60 seconds.
Blood Pressure
Enter the interface and start the blood pressure
measurement. At the same time, the green light of PPG at
the inner side is turned on and the measurement begins.
Data will be visible in about 10 seconds and the full
measurement will take 30-60 seconds.
Hint
: Sensors in the watch measure the highest and lowest value of the photo
-
plethysmographic signal (PPG) - the vessel width change. It is detected by light
irradiation and absorbance measurement. The PPG sensors are located on the
bottom of the watch. To generate the PPG signals, the skin is illuminated with
green LED light, resulting in a reflection of the blood cells under the skin. The
reflected portion is registered and recorded.
