I.SITE III User Manual
© SWISSPHONE Wireless AG
Version 1.1
Page 11/20
Protocol Mode rotary dial:
Use this dial to select one of the available operating modes. Detailed
descriptions of these are provided in the following chapter.
3.4.5
Backup Battery
When there is a power failure, the optional 12V backup battery (2.3Ah) provides power to the
transmission module and the controller board.
3.5 Operating Modes
The I.SITE III provides a number of different operating modes. These are selected via the 16-step
hex rotary dial on the controller board. Following a reset, the position of the operating mode dial is
detected and the transmitter is set to the corresponding mode. The available operating modes are
described below. All other modes are categorized as programming and test modes. To configure
the modes, you need to use the configuration software.
3.5.1
I.SEARCH Slave Mode
0x2
: The transmitter is set to the I.SEARCH Slave protocol.
After start-up or reset, the default operating mode is briefly indicated via the LEDs.
Behavior / display:
I.SEARCH Slave Mode:
The green LED emits three short flashes.
3.5.2
SAGEM Mode
0xD
: The transmitter is set to the SAGEM protocol (type: RM 540-E). Use this for sending text
messages. This mode is only available with the I.SITE SDIS version.
After start-up or reset, the default operating mode is briefly indicated via the LEDs.
Behavior / operating mode display during start-up:
SAGEM Mode:
The green LED emits two short flashes, followed by one flash of the red LED.
3.5.3
ASCII Mode
0xE
: The transmitter is set to the ASCII Simple protocol. With this, you can instantly send ASCII-
encoded messages.
After start-up or reset, the default operating mode is briefly indicated via the LEDs.
Behavior / operating mode display during start-up:
ASCII Mode:
The green LED emits three short flashes, followed by one flash of the red LED.
3.5.4
Programming and Test Mode
0xF
: In this mode, the Programming and Test protocol is used.
After start-up or reset, the default operating mode is briefly indicated via the LEDs.
Behavior / operating mode display during start-up:
Programming/Test Mode:
The green and red LEDs emit alternating flashes
at an increasing speed until the red LED lights up continuously.
This mode is displayed as a fault.
With the I.SITE III, programming can only be performed via Ethernet using the following
IP address and port.
IP address: 192.168.1.3
Port: 6611
