Swiss INDIGO 1200, Инструкция по эксплуатации, Страница: 7 / 11

ATTACHMENTS
HOW TO USE THE ATTACHMENTS:
1. As in fig.10, you can use the compressed brush on corners and crevices. (design may vary)
2. As in fig.11, open the other side with bristles of the compressed brush as the mark of an arrow
to clean the sofa, curtains and crevices in furniture or skirting.
3. As in fig.12, tread on the pedal of the brush tool to expose bristles for flat or wooden floors.
4. As in fig.13 , tread on the pedal of the brush tool again to retract the bristles for use on carpets.
Fig.10 Fig.11
Fig.12 Fig.13
IMPORTANT
MAINTENANCE!!!
1. The main round foam filter located in the lid of the dust chamber should be cleaned out daily,
or whenever there is obvious dirt clogging up the filter.
FAILURE TO DO THIS WILL REDUCE THE LIFE OF THE MACHINE!!! The round
dust filter should be replaced every 3-4 months(depending on state of filter or usage). The
HEPA filter should be replaced every 6-12 months (depending on state of filter or usage)
2. The filter must be installed with the black foam side facing down onto the dust chamber and
white side facing into the lid.
3. The filter can't be cleaned in the washing machine or blown with a hair dryer.
4. The filter can be washed in water(ONLY) and rinsed out and dried !!!!
A wet filter will reduce the suction power and damage the motor!!!
5. Steps for maintenance:
1) As in fig.14, press the outlet lock to open the outlet cover.
2) As in fig.15, remove out the Hepa filter and clean out.
3) As in fig.16, rotate the Pre-motor filter/ Sponge filter cover to separate it from the chamber cover
4) As in fig.17, remove and clean the Pre-motor filter/ Sponge filter.
5)As in fig.18,If you have any dust or obstructions remove and clean out immediately.
6)As in fig.19, disassemble the Pre-motor filter & Sponge filter part and wash.
7)Wash the Pre-motor filter/ Sponge filter cover/ Sponge filter assembly, the outlet
sponge and the dust chamber in water without detergent and dry them out.