Studs must be
flush and square
SHOWER BASE
INSTALLATION INSTRUCTIONS
L
W
L
W
10”
10”
Rough-In
CAUTION: DO NOT
use drywall screws to secure flanges to wall studs. Product
damage will occur and will void the warranty.
Entire bottom support must be in contact with a flat level surface.
1.
Read the complete instruction manual before beginning installation.
2.
Confirm that your model will fit in intended location and plumbing fixtures are
located where legally required before beginning installation.
3.
Not all drawings on this manual are drawn to scale. Please refer to the model chart.
4.
Walls and sub-floor must be solid, flush, and square.
5.
Always use drop cloth to protect shower base from damage during installation.
6.
Two people are recommended to install and move this product.
Roughing-in
•
Rough plumbing must be pre-installed by a certified plumber before shower base
installation.
• If floor drain-hole installation is needed, contact a certified plumber.
10” x 10” Floor cut-out
Wall studs
— 2 —
