Swisher ZT2766KP, Руководство пользователя, Страница: 11 / 42

CUSTOMER RESPONSIBILITIES/SPECIFICATIONS
V-Belts
Check V-belts for deterioration and wear after 100 hours of
operation and replace if necessary. Replace belts if they
begin to slip from wear. SEE SPECIFICATION for belt part
numbers and SERVICE section of this manual for
instructions on how to replace the belt.
Engine
REFER TO YOUR ENGINE OWNERS MANUAL
Overall Unit Care
Reduce the risk of fire by removing grass, leaves,
and other debris that may have accumulated on the
machine. Allow the machine time to cool before cleaning
or putting it in storage.
Wash mower periodically. Clean above and below
deck.
Keep all electrical connections clean and tight.
Driving and Transport
on Public Roads
Check applicable road traffic regulations before driving
and transporting on public roads.
If the machine is transported, you should always use
approved fastening equipment and ensure that the
machine is well anchored.
The cutting deck should also be lowered to the lowest
position and the parking brake engaged.
FRONT: 13 x 6.5 x 6
REAR: 23 x 10.5 x 12
TIRE SIZE
27 + - 3 ft. lbs HYDRO Bolt Torque
Pivoting FRONT AXLE
Electric Actuator DECK LIFT
15” Back w/ Arm Rest
6” Adjustable Slide
Air Ride Suspension With Lumbar
Support.
SEAT
Commercial Grade Eaton Hydrostatic TRANSMISSION
Spring Assisted PARKING BRAKE
1.5” – 5” CUTTING HEIGHT
66” – 3 Mulching Blade System CUTTING WIDTH
LENGTH: 70”
WIDTH: 66 1/4 “
Including Deck
WEIGHT: 950 lbs
UNIT MEASUREMENTS
35 ft. lbs BLADE BOLT TORQUE
12V / Heavy Duty 275 CCA
Type U1L
BATTERY
FRONT: 28 psi Max
REAR: 20 psi Max
TIRE PRESSURE
0 – 8 mph GROUND SPEED
SEE ENGINE MANUAL SPARK PLUG
SEE ENGINE MANUAL OIL TYPE (SPI-SF-SJ):
DUAL 5.0 GAL TANKS
UNLEADED REGULAR
GASOLINE CAPACITY
AND TYPE
11 11
SPECIFICATIONS
6 V 12 V 50 AMPS 30 AMPS 20 AMPS 10 AMPS
6.3 12.6 100%
6.2 12.4 75% 20 MIN. 35 MIN. 48 MIN. 90 MIN.
6.1 12.2 50% 45 MIN. 75 MIN. 95 MIN. 180 MIN.
6 12 25% 65 MIN. 115 MIN. 145 MIN. 280 MIN.
5.9 11.8 0% 85 MIN, 150 MIN. 195 MIN. 370 MIN.
FULL CHARGE
VOLTAGE
STANDARD
BATTERY
STATE
OF
CHARGE
APPROX. BATTERY CHARGING TIME *
TO FULL CHARGE AT 80
o
F/27
o
C
MAXIMUM RATE AT
* Test wet batteries every 4-6 months and recharge if necessary.
Always test and charge if necessary before installation.
•The maximum charge rate in amperes should be no more than 1/3 of the battery’s reserve capacity
minute rating. If the terminal voltage exceeds 16.0 volts while charging, reduce the charge rate.
•Continue charging and reduce the rate as needed until a 2 hour period results in no increase in voltage or
decrease in current.
If violent gassing or spewing of electrolyte occurs, or the battery case feels hot to the touch, temporarily
reduce or halt charging.