Swisher TRAILMOWER POL14560X, Руководство пользователя, Страница: 6 / 16

REQUIRED ASSEMBLY
FRONT WHEEL CASTER ASSEMBLY
1. Remove single nut (1) and washers (2) from caster shaft.
2. Place one washer (2) on the shaft of the caster/wheel sub-assembly. (4)
3. Slide same shaft through the bearing (3) in the frame with wheel towards the ground.
4. Place the other washer (2) on the shaft; it should be resting on the top bearing.
5. Thread nyloc jam nut onto shaft.
6. Tighten nut snuggly, making sure shaft threads enter the nyloc of the nut.
Over-tightening of
this nut will bind caster.
7.
Repeat process for all four casters
OFFSET & CENTER TOW HITCH BAR ASSEMBLY
1. Lay out parts according to the diagram.
2. Insert part 661A into part 662 and pin with the hitch pin (H11).
3. Insert part 661 into part 661A. Choose from the 3 holes to set the desired hitch length. Pin
with a hitch pin.
4. Part 662 slides into the front tube of the frame. Again, choose from the 3 holes to arrange
desired offset. Pin with a hitch pin (H11).
5.
Eliminate step 2 for hitching from the center bracket. Only one method can be used at a time.
Item No. Description Part #
1 5/16 PAL NUT NB276
2 PLASTIC KNOB H7K
3 CRANK ARM ES214
4 ADJUSTER TUBE H7N1TK
5 BUSHING 10579
6 1/2-13 X 7-3/4'' EYE BOLT 10038
Item No. Description Part #
1 3/4-16 JAM NYLOK NUT NB122
2 WASHER NB195
3 BEARING B98
4 CASTER FORK 665TK
5 5/8-11X 7 BOLT NB624
6 5/8-11 2-WAY LOCK NUT NB595
7 WHEEL SPACER 663L
8 WHEEL/TIRE/BEARING F4157W
9 3/8-16 x 3.5 BOLT NB649
10 WASHER NB271
11 3/8-16 NYLOK NUT NB182
12 REAR CASTER 6710TK
6
Bent Pin, Hair Pin
and Receiver
supplied by others.
Existing Rear Hitch.
ATV or Utility Vehicle
Attachment
Instructions
661
661
A
662
H10
H11
1
2
3
4
5
7
8
6
8
9
10
10
11
12
FIGURE - 1
FIGURE - 1 FIGURE - 2
FIGURE - 3
FIGURE - 3
1
2
3
4
5
6
OFFSET TOW
POSTION
CENTER TOW
POSTION