Swisher POL 14560B, Руководство пользователя

Страница: 8 / 16

•
Engine must be on level ground to accurately check and fill oil DO NOT OVER FILL.
•
Make sure the tow vehicle parking brake is set, mower is level, and blades are
disengaged.
•
Check spark plug wire, oil, and fuel.
•
Check all electrical connections (See Schematics).
•
Make sure toggle switch is turned “ON” and the red tether is properly attached.
•
Set engine idle to “CHOKE” position.
•
With feet clear of mower deck, turn key switch to the “START” position; [ if unit is
equipped with 12 volt system ] release when engine begins to run.
•
For units NOT equipped with electric start turn key to “ON” position and pull starter
Rope until engine starts.
•
Set engine idle at desired RPM.
BREAKING IN YOUR MOWER
•
Set vehicle parking brake or chock wheels to prevent accidental rolling.
•
Start engine properly.
•
Then pull the PTO switch located on the console to the out or engage position.
•
In a safe environment, i.e. no children, allow blades to rotate and engine to idle for 5
minutes. This breaks in the belts and the engine.
•
Stop mower properly.
MOWER HEIGHT ADJUSTMENT
•
Adjust deck height while mower is not running.
•
The cutting range is approximately 1.5” to 4.5”. The height has been measured from the
ground to the blade tip without the engine running.
•
Rotate height adjust crank handles (H7N) in a clockwise direction to lift the mower deck.
A counter-clockwise direction is used to lower the mower deck.
•
Make sure the height adjustment is the same at side crank handles. For best results, see
“SUGGESTED PRACTICE” section. Graduated scales are for reference only, not the
actual cutter height.
•
Place crank handle in a retracted position to maintain height adjustment.
STARTING TO MOW
•
Adjust the cutting height.
•
Double check tow vehicle to mower attachment.
•
Start mower engine properly.
•
Let engine run at full throttle for a few seconds then pull the PTO switch located on the
console to the out or engage position.
•
Mount tow vehicle and start mowing slowly.
CAUTION!
SHUT OFF MOWER ENGINE AND REMOVE SPARK PLUG WIRE FROM
SPARK PLUG BEFORE MAKING ANY ADJUSTMENTS TO THE MOWER.
8