Swisher 97-056001, Руководство пользователя, Страница: 13 / 36

11
ADJUSTMENTS AND ROUTINE SERVICING
WARNING - ALWAYS STOP ENGINE AND DISCONNECT SPARK PLUG WIRE
AND BATTERY BEFORE MAKING ADJUSTMENTS OR SERVICING MOWER!
CUTTING HEIGHT ADJUSTMENT:
•
Turn Height Adjustment Crank (H7N)
Clockwise to raise the blade
Counter-Clockwise to lower the blade.
BLADE SHARPENING:
• Remove Blade Nut (B108) from Blade Shaft (B100).
• Remove blades (B32S and B32L) and the appropriate Blade Spacers (B101, B102 and/or B103).
Note the position of the spacers.
• Sharpen the blades.
• When reassembling, make certain that blade spacers are positioned so blade is still under mowing deck.
• Replace the old Blade Nut (B108) with a new one. Make certain the nut and washer are tightened to a minimum
of 95 foot pounds.
LUBRICATION:
Wheel Bearings
- Lubricate the Rear Wheel Bearings three times a year by putting a few drops of standard 30 weight
engine oil on each Wheel Bearing (F157B).
Blade Bearings
- These bearings are sealed and do NOT require additional lubrication.
Gear Box
- Located on the drive unit. After every twenty hours of operation, check the oil level by using the Oil
Check Plug (T143P) located on the front side of the Gear Box. The oil should be level with the Oil Check Plug. Use
only SWISHER Gear Oil (TR124L).
Seat Spring Rods
(A153) - Lubricate with gun grease or petroleum jelly once a year.
Engine
- Refer to your engine manual for engine lubrication care.
BELTS:
Occasionally check belts for wear. A worn belt should be replaced. See REPAIR (page 12) section for instructions.
All manuals and user guides at all-guides.com