Swisher 2645 CORRUGATED PLOW BLADE, Руководство пользователя

Страница: 8 / 12

TO ENSURE PROPER ASSEMBLY AND
INSTALLATION, CAREFULLY
FOLLOW ALL INSTRUCTIONS LISTED BELOW
REFER TO FIGURES 2 AND 3 WHILE ASSEMBLING AND INSTALLING THIS PORTION OF THE
PLOW ATTACHMENT
The next steps need to be done in sequence:
1. Disassemble Pivot Latch assembly from the plow mount. Lay parts down in the exact order they were removed.
Replace lock nuts (25) with lock nuts in hardware kit.
2. Slide the plow mount (19) into pivot weldment (1), secure with ½-13 X 3 1/2 bolt (28) and ½-13 nyloc nut (13).
3. Re-assemble the Pivot Latch assembly in the reverse order that it was removed in step 1. The Pivot Latch
assembly consists of the following components - lock arm (29), two bushing (18), two ½-13 lock nut (25),
Washer (23), pivot spring (24) and ½-13 X 3½ bolt (28) to plow mount (19). Make sure the tail of the pivot
spring is secured into the bent washer on plow mount, see fig 3. Note, lock arm should be able to pivot freely
after assembled.
4. Bolt plow mount bracket (22) and plow bracket support (27) to plow mount (19), as shown, using two 3/8-16 X 3
bolts (30) and two 3/8-16 nyloc nuts (7).
5. Insert ½-13 X 3 bolt (26) into plow mount bracket (22) and secure with ½-13 nyloc nut (13). Do not over tighten
as this can bend the plow mount bracket. This is where you will attach your winch or manual lift pulley, sold
separately.
6. With your Swisher ATV Accessory Mount already installed, attach the plow using plow mount pin (20) and two
3/16 click pins (21).
7. Attach red rope (31) to eyelet on lock arm (29) and loop over front of ATV so it can be reached by the operator.
8. Read Dangers on the back of the Swisher Plow and consult this manual.
9. It would be wise to become familiar with your plow using a slower speed.
10. Operating instructions are on page 9.
Figure 3
8
Tail of Spring 24
29
29
28
18
25
23
24
Top of weldment is removed for clarity.
19
1
Tail of Spring 24
29
25
22