INSTALLATION OF BUCKET ATTACHMENT
TO ENSURE PROPER INSTALLATION, CARFULLY
FOLLOW ALL INSTRUCTIONS LISTED BELOW
REFER TO FIGURE 1 WHILE INSTALLING THE BUCKET ATTACHMENT
1.
BEGIN BY LAYING OUT THE PARTS SIMILAR TO FIGURE 1
2.
ATTACH THE BUCKET HITCH(3) TO THE BUCKET(1) USING BOLTS(6) AND
NUTS (7).
3.
INSTALL THE LATCH REST BOLT(4), ROLLER BUSHING(16) AND NUT(10) TO
THE BUCKET.
4.
PLACE THE BUCKET LATCH(5) IN THE UPRIGHT TABS ON THE BUCKET
HITCH(3) USING BOLT(4) TO HOLD IT THERE.
5.
INSERT THE BENT PART OF THE SPRING(13) INTO THE BUCKET LATCH(5)
ON THE SIDE FACING THE CENTER OF THE BUCKET HITCH(3) AND OVER
THE BOLT (4) GOING THROUGH THE LATCH. THE LONG STRAIGHT PART OF
THE SPRING WILL REST ON TOP OF THE BUCKET HITCH(3).
6.
NEXT, PLACE THE WASHER(14) OVER BOLT (4) ENDING WITH NUT (10),
TIGHTEN THE ASSEMBLY UNTIL THE NUT IS ALL THE WAY ON THE BOLT,
ALLOWING LATCH (5) TO ROTATE FREELY.
7.
PLACE THE ASSEMBLED BUCKET ATTACHMENT IN FRONT OF YOUR
ALREADY INSTALLED
SWISHER
ACCESSORY MOUNT.
8.
INSERT THE PLOW MOUNT PIN(11) THROUGH THE BUCKET HITCH AND THE
ACCESSORY MOUNT.
9.
SECURE THE PIN WITH THE CLICK PINS(12) ON EACH END OF THE MOUNT
PIN.
10.
TIE THE RED TRIP RELEASE ROPE(15) TO THE TOP OF THE BUCKET
LATCH(5).
11.
ATTACH YOUR WINCH HOOK TO THE TOP OF THE BUCKET HITCH,
THROUGH THE EYELET PROVIDED.
