17
Assembly Instructions
(4) 2'' screws
Swing Hanger
Use Screwdriver to aid in tightening
Bottom Beam Clamp
Hammer
3/8'' hole
Fig. 8
T-nut
2'' Wood Screw
cORREcT!
Swing Hanger Assembly
1.
Tap T-nut into 3/8’’ hole as shown in
Step 1
.
2.
Place a bottom beam clamp over the swing hanger as shown in
Step 2
.
3.
Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the T-nut.
A screwdriver may be used to twist the hanger. Orient the Beam Clamp, making sure the slot is parallel with beam
length and the triangle of the Swing Hanger locks securely into the Beam Clamp slot, as shown
in
Step 3
.
4.
Use (4) 2'' screws to secure beam clamp as shown in
Step 4
.
5.
Check hanger to ensure it does not spin.
6.
Repeat for all swing hangers.